RMG Switch V2 with BEC

he RMG SmartSwitch V2 is a water proof ultra low profile battery on/off switch for RC yachts. It can be used with any sailwinch and radio system.
Features common to RMGSwitch V2-BEC and RMGSwitch-Std Super Low Profile. Simple to install. details LED indicator for system status and intelligent battery voltage display. details IP67 (waterproof) very short travel tactile switch. Battery supply range from 5 or 6 cells NimH/NiCd or 2 cells LiFe/LiPo. Minimum voltage for RMGSwitch operation - 3.8V. Short term fluctuations below 3.8V can be tolerated without unlatching. Unlatching voltage - 1.5V. Voltage below this level will cause the RMGSwitch to unlatch requiring a button press to restart. Optional fitting of Deans Ultra type connectors (std Deans wiring configuration). Dimensions 30mm x 24mm x 35mm. weight 30g. Note that 4 cell NimH/NiCd batteries can not be used to power the RMGSwitch BEC. And while 5 cell NimH/NiCd batteries can be used, 6 cells or 2 cell LiPo are recommended for the RMGSwitch. The receiver voltage will remain at 6V while the actual battery voltage is above 7.2V but will fall below 6V as the battery falls below 7.2. For example, at battery voltage of 6V the receiver supply will be 4.8V. When a 5 cell pack is flat (5.5V) the receiver will only be supplied 4.3V. Most receiver and servos will operate at this lower level but the servos connected to the receiver will be less powerful and slower